DRYCO is unveiling the SBDH-200!
This small unit has been built specifically for drying marine vessels.
Features include:
• 200cfm • Electric • 460 volt 3 phase • 5amps • 175lbs • L:20 x W:17 x H:38
• ANSI lifting bar made with dual 12 gauge 304 stainless steel angle
• 18 gauge 304 stainless steel casing, access doors and panels
• Three smooth sides for easy handling with hand truck and when
transporting below deck
• Solid state PTC heater elements – no requirement for high
temperature limit switch
• Gasketed access panel for user mounted data logger
• Easily accessible UL approved control panel on top of unit
• All circuits protected with circuit breakers – no fuses
• Electronic humidity sensor and LED control panel
• Automatic phase switch
• Full access to internal components from two sides
• Two blowers, process and reactivation
• Process blower operates continuously, while reactivation
heaters activate with humidity load
• Three 80 micron/10 micron disposable pleated paper filters in:
process inlet, process outlet and reactivation supply
• Filters are 10-Micron 1st stage and 80-Micron 2nd stage
part # CFS-8H-105W-7/8 NSN 4130-01-548-1951
Downloadable materials on the unit can be found here:
Spec Sheet
Informational Literature