Chicago | Seattle | San Francisco | Los Angeles | San Diego | Las Vegas | Houston | St. Louis | Cincinnati | Atlanta | New Orleans | Tampa Bay | Boston | Hartford | Philadelphia | Norfolk (866) 379-2600

New Drying Equipment for Military Vessels – Small Spaces

DRYCO is unveiling the SBDH-200!
This small unit has been built specifically for drying marine vessels.

Features include:

• 200cfm  •  Electric  •  460 volt 3 phase  • 5amps  • 175lbs  •  L:20 x W:17 x H:38

• ANSI lifting bar made with dual 12 gauge 304 stainless steel angle

• 18 gauge 304 stainless steel casing, access doors and panels

• Three smooth sides for easy handling with hand truck and when
   transporting below deck

• Solid state PTC heater elements – no requirement for high
   temperature limit switch

• Gasketed access panel for user mounted data logger

• Easily accessible UL approved control panel on top of unit

• All circuits protected with circuit breakers – no fuses

• Electronic humidity sensor and LED control panel

• Automatic phase switch

• Full access to internal components from two sides

• Two blowers, process and reactivation

• Process blower operates continuously, while reactivation
  heaters activate with humidity load

• Three 80 micron/10 micron disposable pleated paper filters in: 
   process inlet, process outlet and reactivation supply

• Filters are 10-Micron 1st stage and 80-Micron 2nd stage
   part #  CFS-8H-105W-7/8     NSN 4130-01-548-1951

Downloadable materials on the unit can be found here:


Spec Sheet
Informational Literature